Advertise | Subscribe | Contact Us | Connect with us    
 

Understanding Seals Fresno CA

It has been a long drive to the lake. The driver carefully backs the trailer down the boat ramp. As the axles hit the water, the hot wheel bearing hubs hit the water. As the bearings' heat is quenched by the lake water on the outside of the hub, the rapidly contracting air and lubricants inside the hub create a vacuum. If this vacuum can not be held by the seals, the hub will suck in water and contaminates.

Triple A Automotive
(559) 321-7103
906 Barstow
Clovis, CA
Cars
(559) 485-7296
2229 E McKinley Avenue
Fresno, CA
Brownie Muffler Service
(559) 237-2081
3316 E Ventura Avenue
Fresno, CA
Goodguys Tire Center
(559) 221-1438
4140 N Blackstone Avenue
Fresno, CA
D & R Automotive of Fresno Inc
(559) 266-6060
901 M Street
Fresno, CA
Belmont Tire & Automotive
(559) 485-8970
1449 E Belmont Avenue
Fresno, CA
Blackstone Brake & Auto Repair
(559) 264-7863
1558 N Effie Street%2C %23 102
Fresno, CA
Rick's Tire & Service
(559) 485-7970, 001-2004
1501 Fulton Street
Fresno, CA
A & J Auto Repair
(559) 222-3912
4323 N Blackstone Avenue %23 B
Fresno, CA
Goodguys Tire Center
(559) 237-9383
2530 N Weber Avenue
Fresno, CA
Data Provided by:
 
Provided By: 

Understanding Seals

It has been a long drive to the lake. The driver carefully backs the trailer down the boat ramp. As the axles hit the water, the hot wheel bearing hubs hit the water. As the bearings' heat is quenched by the lake water on the outside of the hub, the rapidly contracting air and lubricants inside the hub create a vacuum. If this vacuum can not be held by the seals, the hub will suck in water and contaminates.

While this is an extreme example, this type of contamination can happen to all bearings if the seals are not in good condition. It is clear to see, the most important part of bearings is the seal. If contaminates are able to work there way onto the contact surfaces, or the lubricant is expelled, the bearing will not last long.

Seal Materials
Wheel bearings, seals and hub units can operate at extreme temperatures. On front-wheel drive, and 4WD vehicles, the seals can be subjected to heat from the bearings and the brake system.

This harsh environment can stress the design of the seal, in addition to being very stressful on the physical materials used to make the seal.

Standard seals are often made of nitrile. Nitrile is an economical material that works well with most mineral greases and oils. It will last in temperatures as low as -40º F, but its weakness is high temperatures. Nitrile doesn't last too long at temperatures above 225º F. Polyacrylate seals fare much better at temperatures up to 300º F, making them more suitable for demanding, high temperatur...

Click here to read the rest of the article at Tire Review